Oversize punching unit for diameters up to 160 mm

GEKA’s oversize punching unit for diameters up to 160 mm is an ironworker tool that allows operators to punch a wide range of hole punch diameters and geometric figures on flat surfaces from 3 mm to 160 mm of punch diameter. The punch must have the desired shape and figure, which should circumscribe to a small diameter hole punch diameter of up to 160 mm. The die must have the same shape with proportional set to the thickness of the material.

CAUTION: Never punch a hole punch diameter smaller than the material thickness. It is very important to apply the correct gap between punch and die.

This large diameter whole punch is available for the Puma Series of punching machines and for the Hydracrop 55, 80, 110 and 165 models.

If you would like to purchase a custom tool for punching in large diameters, standard hole punch diameters or any custom parts for your Geka ironworker, please contact GEKA. Our technical service is available to help you and will be able to design a tailor-made solution. You can send us a sketch with the idea that you have in mind, including the shape and size for the part, and our technical service will evaluate the feasibility of the design. All of our custom tools can be adjusted to the standard machine easily and quickly.

Other punching tools

If you are looking for tools and accessories with which to complete other punching tasks, you can learn more about the following GEKA punching tools through the following links: